Hazard-zone alerts
Workers are notified the instant they enter a geofenced hazard zone — swing radii, excavations, live equipment, restricted areas.
Connect Up is the connected-worker platform for high-risk industries. We detect hazards the moment a worker approaches one — and turn every near-miss into data that makes the whole site safer.
Built with · trusted by · recognized across the safety ecosystem
Most safety programs measure incidents after they occur. Connect Up works upstream — sensing risk in real time and intervening in the seconds that matter, while quietly building the record that proves it worked.
Workers are notified the instant they enter a geofenced hazard zone — swing radii, excavations, live equipment, restricted areas.
Location-aware safety procedures surface exactly where they apply, so the right precaution reaches the right worker at the right moment.
Data is collected without identifying individuals — protecting worker privacy and earning the trust that adoption depends on.
Real-time incident notifications with a replayable timeline — understand exactly what happened, resolve disputes, and close the loop.
Turn site activity into reports that cut operational cost — surfacing the patterns behind risk before they become claims.
Workforce timing and break compliance handled in the same system, reducing overhead and administrative drag.
From the control room to the individual worker, Connect Up gives every stakeholder the safety picture they need — live and consistent. These are the real Sentinel screens, in production on active sites.
A private, anonymized safety and time history for every worker — exposures, breaks, and device status, without surveillance.
Trends across crews, sites, and time — the evidence base for lower incident rates and stronger insurance positions.
Volpatt Construction was replacing the convention center's public terrace — a sloped, 40,000-square-foot flat roof that had leaked for years, sending rainwater into the concourses below. Crews faced real fall exposure on the incline, spread across a site that was hard to monitor in real time.
“It was leaking in spots. We kept repairing it, but it's gotten to the point where we needed to replace it.” State Sen. Wayne Fontana — SEA Board Chairman
Connect Up equipped the crew with wearable devices and Bluetooth beacons: proximity sensors flagged PPE zones around the roof edge, slip-trip-and-fall detection watched every worker, and geofenced hazard zones wrapped the worksite. Digital safety huddles and procedures were pushed straight to the workforce, with check-in/out and location heatmaps for the team.
Incidents were detected and escalated to supervisors and owners in real time, sharpening both safety culture and day-to-day efficiency across the project — and turning a high-risk job into a measurable insurance win.
Build a measurable safety culture and reduce operational expense — with proof that the program is working, not just policy on paper.
Protection on the job and privacy off it. Alerts reach the worker, not a manager watching a dot — adoption workers actually trust.
Fewer incidents and a defensible forensic record — the data that supports better claims outcomes and stronger premiums.
Connect Up brings both safety and innovation to the construction industry and is helping to redefine the way we optimize our workforce and reduce our incident rates.
Raymond Volpatt Jr.President, Volpatt ConstructionWe are proud to be an inaugural reseller of Connect Up in the construction industry — bringing workplace safety and optimization to a marketplace that is ripe for innovation.
High-risk industries carry the highest human and financial cost of preventable incidents — and the least modern tooling to stop them. Connect Up sits at the intersection of regulation, insurance, and connected hardware, compounding value with every site it protects.
Walk through the live platform with our team. We'll map it to your sites, your risk profile, and your numbers — investor or operator, this is the fastest way to understand what Connect Up changes.